ZyXEL VES1724-56 User Guide - Page 156
Advanced Application, Static Multicast Forwarding
View all ZyXEL VES1724-56 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 156 highlights
Chapter 12 Static Multicast Forward Setup Click Advanced Application > Static Multicast Forwarding to display the configuration screen as shown. Figure 84 Advanced Application > Static Multicast Forwarding The following table describes the labels in this screen. Table 53 Advanced Application > Static Multicast Forwarding LABEL Active Name MAC Address VID Port Add Cancel Clear Index Active Name MAC Address VID Port DESCRIPTION Select this check box to activate your rule. You may temporarily deactivate a rule without deleting it by clearing this check box. Type a descriptive name (up to 32 printable ASCII characters) for this static multicast MAC address forwarding rule. This is for identification only. Enter a multicast MAC address which identifies the multicast group. The last binary bit of the first octet pair in a multicast MAC address must be 1. For example, the first octet pair 00000001 is 01 and 00000011 is 03 in hexadecimal, so 01:00:5e:00:00:0A and 03:00:5e:00:00:27 are valid multicast MAC addresses. You can forward frames with matching destination MAC address to port(s) within a VLAN group. Enter the ID that identifies the VLAN group here. If you don't have a specific target VLAN, enter 1. Enter the port(s) where frames with destination MAC address that matched the entry above are forwarded. You can enter multiple ports separated by (no space) comma (,) or hyphen (). For example, enter "3-5" for ports 3, 4, and 5. Enter "3,5,7" for ports 3, 5, and 7. Click Add to save your rule to the Switch's run-time memory. The Switch loses this rule if it is turned off or loses power, so use the Save link on the top navigation panel to save your changes to the non-volatile memory when you are done configuring. Click Cancel to reset the fields to their last saved values. Click Clear to begin configuring this screen afresh. Click an index number to modify a static multicast MAC address rule for port(s). This field displays whether a static multicast MAC address forwarding rule is active (Yes) or not (No). You may temporarily deactivate a rule without deleting it. This field displays the descriptive name for identification purposes for a static multicast MAC address-forwarding rule. This field displays the multicast MAC address that identifies a multicast group. This field displays the ID number of a VLAN group to which frames containing the specified multicast MAC address will be forwarded. This field displays the port(s) within a identified VLAN group to which frames containing the specified multicast MAC address will be forwarded. 156 VES1724-56 User's Guide