ZyXEL VES1724-56 User Guide - Page 93

Chapter 8 Basic Setting Table 18 Remote CPE Configuration (continued) LABEL DESCRIPTION Wan Specify the CPE's WAN connection (1~4) through which to forward the traffic that matches this classification rule. Queue Specify a CPE's queue (1~4) that applies to this classification rule. Filter This section defines two sets of classification criteria (Set-1 and Set-2). Lan Specify which Ethernet port traffic of this classifier should come. Enter a number between 1 to 5 when the Virtual Port function is enabled or between 1 to 3 when it is disabled in the device. Protocol Specify the protocol (1:TCP/UDP, 2:TCP, 3:UDP or 4:ICMP) for the service type. Source/ Destination Informatio n IP: Enter the source/destination IP address in dotted decimal notation. Mask: Enter the source/destination subnet mask. Mac: Enter the source/destination MAC address of the packet. Mac Mask: Type the mask for the specified MAC address to determine which bits a packet's MAC address should match. Enter "f" for each bit of the specified source MAC address that the traffic's MAC address should match. Enter "0" for the bit(s) of the matched traffic's MAC address, which can be of any hexadecimal character(s). For example, if you set the MAC address to 00:13:49:00:00:00 and the mask to ff:ff:ff:00:00:00, a packet with a MAC address of 00:13:49:12:34:56 matches this criteria. Start Port: Enter the starting port number of the source/destination. End Port: Enter the ending port number of the source/destination. Priority Enter a priority level (0~7). "0" is the lowest priority level and "7" is the highest. prtcl-type Enter a protocol type (0600~FFFF). Add/Apply Click this to add a new classification rule or apply the changes for an existing classification rule on the Switch. Port Config Index Specify a LAN port (1~4) on the CPE device. Speed Specify a number (1:auto, 2:10H, 3:10F, 4:100H, 5:100F) for the port speed and duplex setting where H represents half-duplex and F represents full-duplex. mnt Console Use this section to configure the console port settings for the CPE device. Active Select Enable to activate multiple user login (using the Admin and User accounts) through the CPE's console port. Otherwise, select Disable to deactivate it. Admin Enter a new admin password (up to 16 characters) for the CPE device. Note that as you type a password, the screen displays a (*) for each character you type. User Enter a new user password (up to 16 characters) for the CPE device. Note that as you type a password, the screen displays a (*) for each character you type. Layer2 Setting IGMP Select Enable to turn IGMP Snooping on in the CPE device or select Disable to turn it off. Snooping Unknown Multicast Select Block to have the CPE device block all unknown multicast packets from the WAN or select Forward to broadcast unknown multicast packets from the WAN to all LAN ports. Lan Setting IP Enter the LAN IP address and subnet mask in the IP and Mask fields if you want to change them for the CPE device. DHCP Disable Select this if you do NOT want to configure this setting for the CPE device. Clear this to have the Switch send this setting changes to the CPE after you click Apply. VES1724-56 User's Guide 93