ZyXEL VES1724-56 User Guide - Page 256
Advanced Application > IP Source Guard >, DHCP Snooping > Con gt; Port
View all ZyXEL VES1724-56 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 256 highlights
Chapter 26 IP Source Guard Table 108 DHCP Snooping Configure (continued) LABEL Write delay interval Renew DHCP Snooping URL DESCRIPTION Enter how long (10-65535 seconds) the Switch waits to update the DHCP snooping database the first time the current bindings change after an update. Once the next update is scheduled, additional changes in current bindings are automatically included in the next update. Enter the location of a DHCP snooping database, and click Renew if you want the Switch to load it. You can use this to load dynamic bindings from a different DHCP snooping database than the one specified in Agent URL. Apply Cancel When the Switch loads dynamic bindings from a DHCP snooping database, it does not discard the current dynamic bindings first. If there is a conflict, the Switch keeps the dynamic binding in volatile memory and updates the Binding collisions counter in the DHCP Snooping screen (Section 26.4 on page 252). Click Apply to save your changes to the Switch's run-time memory. The Switch loses these changes if it is turned off or loses power, so use the Save link on the top navigation panel to save your changes to the non-volatile memory when you are done configuring. Click this to reset the values in this screen to their last-saved values. 26.5.1 DHCP Snooping Port Configure Use this screen to specify whether ports are trusted or untrusted ports for DHCP snooping. Note: If DHCP snooping is enabled but there are no trusted ports, DHCP requests cannot reach the DHCP server. You can also specify the maximum number for DHCP packets that each port (trusted or untrusted) can receive each second. To open this screen, click Advanced Application > IP Source Guard > DHCP Snooping > Configure > Port. Figure 148 DHCP Snooping Port Configure 256 VES1724-56 User's Guide