ZyXEL VES1724-56 User Guide - Page 328
Configuring SNMP Trap Group, Setting Up Login Accounts
View all ZyXEL VES1724-56 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 328 highlights
Chapter 38 Access Control 38.3.5 Configuring SNMP Trap Group Click Management > Access Control > SNMP > Trap Group to view the screen as shown. Use the Trap Group screen to specify the types of SNMP traps that should be sent to each SNMP manager. Figure 202 Management > Access Control > SNMP > Trap Group The following table describes the labels in this screen. Table 154 Management > Access Control > SNMP > Trap Group LABEL Trap Destination IP DESCRIPTION Select one of your configured trap destination IP addresses. These are the IP addresses of the SNMP managers. You must first configure a trap destination IP address in the SNMP Setting screen. Type Options Use the rest of the screen to select which traps the Switch sends to that SNMP manager. Select the categories of SNMP traps that the Switch is to send to the SNMP manager. Select the individual SNMP traps that the Switch is to send to the SNMP station. See Section 38.3.3 on page 322 for individual trap descriptions. Apply Cancel The traps are grouped by category. Selecting a category automatically selects all of the category's traps. Clear the check boxes for individual traps that you do not want the Switch to send to the SNMP station. Clearing a category's check box automatically clears all of the category's trap check boxes (the Switch only sends traps from selected categories). Click Apply to save your changes to the Switch's run-time memory. The Switch loses these changes if it is turned off or loses power, so use the Save link on the top navigation panel to save your changes to the non-volatile memory when you are done configuring. Click Cancel to begin configuring this screen afresh. 38.3.6 Setting Up Login Accounts Up to five people (one administrator and four non-administrators) may access the Switch via Web Configurator at any one time. • An administrator is someone who can both view and configure Switch changes. The username for the Administrator is always admin. The default administrator password is 1234. 328 VES1724-56 User's Guide