2012 Chrysler Town & Country Owner Manual - Page 19

THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 17 • This device must accept any interference that may be Rearming Of The System received, including interference that may cause unde- The Vehicle Security Alarm will rearm itself after the 15 additional minutes of headlights and Vehicle Security sired operation. Light flashing, if the Vehicle Security Alarm has not been VEHICLE SECURITY ALARM - IF EQUIPPED disabled. If the condition which initiated the alarm is still The Vehicle Security Alarm monitors the vehicle doors present, the Vehicle Security Alarm will ignore that for unauthorized entry and the ignition switch for unau- condition and monitor the remaining doors and ignition. thorized operation. When the alarm is activated, the interior switches for door locks, power sliding doors and To Arm The System power liftgate are disabled. The Vehicle Security Alarm Follow these steps to arm the Vehicle Security Alarm: provides both audible and visible signals, for the first 1. Remove the key from the ignition system (refer to three minutes, the headlights will turn on, the park lamps ЉStarting ProceduresЉ in ЉStarting And OperatingЉ for and/or turn signals will flash and Vehicle Security Light further information). will flash repeatedly and the horn will sound. For an additional 15 minutes, only the headlights, park lamps • For vehicles equipped with Keyless Enter-N-Go, make and/or turn signals and Vehicle Security Light will flash. sure the vehicle ignition system is ЉOFFЉ. • For vehicles not equipped with Keyless Enter-N-Go, make sure the vehicle ignition system is ЉOFFЉ and the key is physically removed from the ignition. 2