2012 Chrysler Town & Country Owner Manual - Page 294
2012 Chrysler Town & Country Manual
Page 294 highlights
292 UNDERSTANDING YOUR INSTRUMENT PANEL CHAngE OIL LoW tirE When the appropriate condition exists, the odometer Your vehicle is equipped with an engine oil change display will toggle between LoW and tirE for three cycles. indicator system. The CHAngE OIL message will flash in the instrument cluster odometer for approximately gASCAP 12 seconds, after a single chime has sounded, to indicate If the vehicle diagnostic system determines that the fuel the next scheduled oil change interval. The engine oil filler cap is loose, improperly installed, or damaged, a change indicator system is duty cycle-based, which "gASCAP" message will display in the odometer display means the engine oil change interval may fluctuate area. Tighten the fuel filler cap properly and press the dependent upon your personal driving style. STEP button on the steering wheel to turn off the message. If the problem continues, the message will Unless reset, this message will continue to display each time you turn the ignition switch to the ON/RUN appear the next time the vehicle is started. position. To turn off the message temporarily, press and noFUSE release the STEP button on the steering wheel. To reset If the vehicle diagnostic system determines that the the oil change indicator system (after performing the Ignition Off Draw (IOD) fuse is improperly installed, or scheduled maintenance), perform the following steps. damaged, a "noFUSE" message will display in the odometer display area. For further information on fuses and 1. Turn the ignition switch to the ON/RUN position (do fuse locations refer to "Fuses" in "Maintaining Your not start the engine). Vehicle".