2012 Chrysler Town & Country Owner Manual - Page 295

UNDERSTANDING YOUR INSTRUMENT PANEL 293 2. Fully depress the accelerator pedal, slowly, three times If the ABS light remains on or turns on while driving, it indicates that the Anti-Lock portion of the brake system within 10 seconds. is not functioning and that service is required. However, 3. Turn the ignition switch to the OFF/LOCK position. the conventional brake system will continue to operate NOTE: If the indicator message illuminates when you normally if the BRAKE warning light is not on. start the engine, the oil change indicator system did not If the ABS light is on, the brake system should be serviced reset. If necessary, repeat these steps. as soon as possible to restore the benefits of Anti-Lock brakes. If the ABS light does not turn on when the Electronic Vehicle Information Center ignition switch is turned to the ON/RUN position, have (EVIC) Display - If Equipped The Electronic Vehicle Information Center (EVIC) fea- the light inspected by an authorized dealer. tures a driver-interactive display that is located in the 8. Tire Pressure Monitoring Telltale Light - If instrument cluster. For further information, refer to Equipped "Electronic Vehicle Information Center (EVIC)". Each tire, including the spare (if provided), should be checked monthly when cold and 7. Anti-Lock Brake (ABS) Light inflated to the inflation pressure recommended This light monitors the Anti-Lock Brake System by the vehicle manufacturer on the vehicle (ABS). The light will turn on when the ignition switch is turned to the ON/RUN position and placard or tire inflation pressure label. (If your vehicle has tires of a different size than the size indicated on the may stay on for as long as four seconds. 4