2012 Chrysler Town & Country Owner Manual - Page 34

32 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE • The park lights will turn on and remain on during into the ignition switch and move it to the ON/RUN position), otherwise the engine will shut off at the end of Remote Start mode. 15- minute cycle. • For security, power window and power sunroof operation (if equipped) are disabled when the vehicle is To Exit Remote Start Mode And Drive The Vehicle Before the end of the 15-minute cycle, press and release in the Remote Start mode. the UNLOCK button on the RKE transmitter to unlock • The engine can be started two consecutive times (two the doors and disarm the Vehicle Security Alarm (if 15 minutes cycles) with the RKE transmitter. However, equipped). Then, prior to the end of the 15-minute cycle, the ignition switch must be cycled by pushing the press and release the START/STOP button. If the START/STOP button twice (or the ignition switch START/STOP button is not present, insert the Key Fob must be cycled to the ON/RUN position). into the ignition switch and turn the switch to the To Enter The Vehicle After Remote Start ON/RUN position. To enter the vehicle while the engine is running during a NOTE: Remote Start, you must first unlock the vehicle using the • The ignition switch must be in the ON/RUN position UNLOCK button on the RKE transmitter. After the in order to drive the vehicle. vehicle is unlocked, you can enter the vehicle, press and release the START/STOP button (or insert the Key Fob • For vehicles equipped with the Electronic Vehicle Information Center (EVIC), the message "Insert Key/ Turn to ON" will flash in the EVIC until you insert the