2012 Chrysler Town & Country Owner Manual - Page 598

596 MAINTAINING YOUR VEHICLE Front Side Marker Lamp Fog Lamp 1. Raise the hood to access the rear of the headlamp NOTE: Access to the fog lamp bulb is from the rear of housing. the fascia. On the left rear side of the fascia, remove the push pin and lower the hinged access door on the air NOTE: Access is somewhat limited. You may have to dam. remove the inner fender well or remove the headlamp housing for bulb replacement. 1. From behind the bumper fascia, or the access panel on the air dam, twist the bulb counterclockwise, and remove 2. Twist the socket and remove from the headlamp bulb. housing, then pull the bulb out. 3. Push the new bulb into the socket and reinstall the socket by twisting until locked into the headlamp housing. CAUTION! Do not touch the new bulb with your fingers. Oil contamination will severely shorten bulb life. If the bulb comes in contact with an oily surface, clean the bulb with rubbing alcohol. 2. Disconnect wire harness from the bulb.