2012 Chrysler Town & Country Owner Manual - Page 245

UNDERSTANDING THE FEATURES OF YOUR VEHICLE 243 Reprogramming A Single HomeLink௡ Button Security To reprogram a channel that has been previously trained, It is advised to erase all channels before you sell or turn follow these steps: in your vehicle. 1. Turn the ignition switch to the ON/RUN position. To do this, press and hold the two outside buttons for 20 seconds until the red indicator flashes. Note that all 2. Press and hold the desired HomeLink௡ button until channels will be erased. Individual channels cannot be the indicator light begins to flash after 20 seconds. Do not erased. release the button. The HomeLink௡ Universal Transceiver is disabled when 3. Without releasing the button proceed with the Vehicle Security Alarm is active. "Canadian/Gate Operator Programming" Step 2 and follow all remaining steps. Using HomeLinkா To operate, press and release the programmed HomeLink௡ button. Activation will now occur for the programmed device (i.e., garage door opener, gate operator, security system, entry door lock, home/office lighting, etc.,). The hand-held transmitter of the device may also be used at any time. 3