Brother International HL 5030 Service Manual - Page 129
Remove the two pan washer M2.6x6 Taptite screws., Remove the heat roller 25., Remove the halogen lamp.
View all Brother International HL 5030 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 129 highlights
CHAPTER 4 DISASSEMBLY AND RE-ASSEMBLY (10) Remove the two pan (washer) M2.6x6 Taptite screws. (11) Remove the heat roller 25. (12) Remove the halogen lamp. Screw, pan (washer) M2.6x6 Heat roller 25 FU frame upper Heat roller 25 Halogen lamp Screw, pan (washer) M2.6x6 Colored side 115V:Orange 230V:Black Halogen lamp connector plate Halogen lamp Fig. 4-55 NOTE: When re-assembling the halogen heater lamp, ensure that the direction of the halogen heater lamp is correct referring to the figure above. ! CAUTION: • Never touch the surface of the halogen heater lamp. • When securing the screw to assemble the halogen lamp connector plate, ensure you use the plastic jig as shown in the figure below to avoid damaging the edge of the halogen heater lamp. Halogen lamp connector plate Screw, pan (washer) M2.6x6 Halogen heater lamp Plastic jig Fig. 4-56 4-32