Canon XA20 Instruction Manual - Page 166
Wi-Fi cannot be used while the wireless microphone is attached
View all Canon XA20 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 166 highlights
Troubleshooting 166 Unable to complete WPS. - Turn off the camcorder and access point. After a short while, turn them on again and try again. If the problem persists, perform setup using the [Search for Access Points] option (A 137). Unable to complete WPS. Try the operation again. - Some access points require pressing and holding the Wi-Fi Protected Setup (WPS) button. For details, refer to the instruction manual of your access point. - Make sure to touch [OK] on the camcorder's screen within 2 minutes of activating the Wi-Fi Protected Setup signal on the access point, whether by pressing the button or by entering the PIN code. Unable to connect - Cordless phones, microwave ovens, refrigerators and other appliances may interfere with the wireless signal. Try using the camcorder in a location farther away from such appliances. Unable to obtain an IP address - If you are not using a DHCP server, connect using the [Manual Setup] option and enter the IP address using the [Manual] option (A 138). - Turn on the DHCP server. If it is already on, make sure it is functioning properly. - Make sure the address range for the DHCP server is sufficient. - Turn on the DNS server. If it is already on, make sure it is functioning properly. - Make sure that the DNS server's IP address and the name for that address are correctly configured. - Set the DNS server's IP address in the camcorder. - If you are not using a DNS server, set the DNS address to [0.0.0.0]. - If you are using a wireless gateway router, make sure all of the devices in the network, including the camcorder, are configured with the correct gateway address. Wi-Fi authentication unsuccessful - Make sure the camcorder and access point are using the same authentication/encryption method and encryption key. - If the access point is using MAC address filtering, enter the camcorder's MAC address in the access point's configuration screen. Wi-Fi cannot be used while the wireless microphone is attached - The camcorder's Wi-Fi functions cannot be used while the optional WM-V1 Wireless Microphone is connected to the camcorder. Disconnect the microphone from the MIC terminal and turn it off. Wi-Fi connection terminated - Cordless phones, microwave ovens, refrigerators and other appliances may interfere with the wireless signal. Try using the camcorder in a location farther away from such appliances. - The camcorder may not be able to connect to the access point if too many devices are accessing it. After a short while, establish the connection again. Wi-Fi error Incorrect authentication method - Make sure the camcorder and access point are correctly configured. - Make sure the camcorder and access point are using the same authentication/encryption method and encryption key. - If the access point is using MAC address filtering, enter the camcorder's MAC address in the access point's configuration screen. Wi-Fi error Incorrect encryption key - The encryption key (password) is case sensitive so make sure to enter it correctly.