Canon imageCLASS MF5770 imageCLASS MF5700 Series Software Guide - Page 127

Scanning Advanced Mode - Specifying the Parameters of a Scan You can specify the parameters of a scan by selecting a part of the image. When you scan again, only the part of the image you have specified is scanned. You can specify the parameters of a scan with one of the following methods. To Select the Parameters of a Scan Automatically After previewing, on the Toolbar, click . Clicking this button allows you to gradually crop off the image outside the borders detected in the preview image. To Specify the Parameters of a Scan 3 1 To maintain the current width and height proportions set for the image even after selecting the parameters of the scan, click in the [Input Settings]. 2 Do one of the following. ● Specify by dragging ❑ Click . Then click and drag from the upper left corner of the parameter you wish to specify to the lower right of the parameter. To adjust even further, drag the corner or border of the selected parameters. ● Specify size ❑ In (Width) and (Height), enter the parameters you want. NOTE If you clicked in step 1, entering either decides the other parameter. (Width) or (Height) automatically 3 To move the crop border you have selected, place the mouse pointer inside the crop border, then drag. 4 To preview the image, click [Preview]. To delete the settings, click on an area outside of the crop border. Setting Preferences and Scanning with ScanGear MF 3-25