Compaq AP200 Reference Guide - Page 117
Under the Computer Setup, Contact your Compaq
UPC - 743172868534
View all Compaq AP200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 117 highlights
6-15 Solving Network Problems Continued Problem Cause System cannot autosense the network. Solution Disable autosensing capabilities and force the system into the correct operating mode. See Chapter 3, "Intelligent Manageability." Diagnostics reports a failure The cable is not securely connected. Ensure that the cable is securely attached to the network connector and that the other end of the cable is securely attached to the correct device. The cable is attached to the incorrect connector. Ensure that the cable is attached to the correct connector. There is a problem with the cable or a device at the other end of the cable. Ensure that the cable and device at the other end are operating correctly. The network controller is defective. Contact your Compaq authorized service provider. Network controller interrupt with an expansion board. Under the Computer Setup Advanced menu, change the resource settings for the board. Diagnostics passes, but the workstation does not communicate with the network Network driver is not loaded, or driver parameters do not match current configuration. Make sure the network driver is loaded and that the driver parameters match the configuration of the network controller. Continued Compaq Professional Workstation AP200 Reference Guide