Compaq AP200 Reference Guide - Page 80
Removing an Expansion Board
UPC - 743172868534
View all Compaq AP200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 80 highlights
4-16 Hardware Upgrades Removing an Expansion Board 1. Turn off the workstation and any external devices, then disconnect the power cord from the grounded AC outlet. Disconnect the network cable and any external devices from the system. IMPORTANT: On a power-managed system, the power cord MUST be disconnected from the grounded AC outlet. 2. Remove the workstation access panel. 3. Disconnect any cables attached to the expansion board. 4. Remove the screw at the side of the expansion slot. 5. Hold the board at each end and carefully rock it back and forth until the connectors pull free from the slot. Be sure not to scrape the board against other components. Figure 4-12. Removing an expansion board 6. Store the board in antistatic packaging. 7. Install an expansion slot cover to close the open slot. 8. Replace the workstation access panel.