Compaq AP200 Reference Guide - Page 94
Recon the workstation, if necessary. See the When
UPC - 743172868534
View all Compaq AP200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 94 highlights
4-30 Hardware Upgrades 1 2 3 Figure 4-23. Connecting the drive cables to the system board: 1 IDE diskette drive connector, 2 IDE Ultra ATA hard drive connector 3 IDE CD-ROM connector 9. If necessary, remove the bezel blank from the subpanel inside the front bezel. See the section "Removing the Bezel Blank." 10. Replace the workstation access panel. 11. Plug the network cable back into the system. Plug the power cord back into the grounded AC outlet. Reconnect external devices. 12. Reconfigure the workstation, if necessary. See the "When to Reconfigure the Workstation" section in this chapter.
4-30
Hardware Upgrades
1
2
3
Figure 4-23.
Connecting the drive cables to the system board:
1
IDE diskette drive connector,
2
IDE Ultra ATA hard drive connector
3
IDE CD-ROM connector
9.
If necessary, remove the bezel blank from the subpanel inside the front
bezel. See the section “Removing the Bezel Blank.”
10.
Replace the workstation access panel.
11.
Plug the network cable back into the system. Plug the power cord back
into the grounded AC outlet. Reconnect external devices.
12.
Reconfigure the workstation, if necessary. See the “When to
Reconfigure the Workstation” section in this chapter.