Dell PowerEdge 840 Hardware Owner's Manual (PDF) - Page 51
See Installing an Expansion Card on If a controller card was supplied with the drive
View all Dell PowerEdge 840 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 51 highlights
Figure 3-6. Installing or Removing an Optical or Tape Drive 3 2 1 4 5 1 5.25-inch drive 4 power cable 2 drive bay 5 interface cable 3 screws (2) 7 If a controller card was supplied with the drive, install the controller card in expansion slot 3, 4, or 5. See "Installing an Expansion Card" on page 72. 8 Connect a power cable to the drive. See Figure 3-6. 9 Connect the interface cable to the drive and to the appropriate connector on the system board or controller card (if applicable). NOTE: See the documentation that is included with the controller card for more information. If you are installing an IDE device (such as an optical drive), connect the interface cable to the IDE device and the IDE connector on the system board. See Figure 3-7. Installing System Components 51