Dell PowerEdge 840 Hardware Owner's Manual (PDF) - Page 62
Connect the SAS data cable to the SAS controller card, and to the SAS interface connector on - bmc controller
View all Dell PowerEdge 840 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 62 highlights
Figure 3-12. Installing the SAS Backplane Board 2 1 3 4 5 1 release tab 4 data cable 2 power connector 5 power cable 3 I2C connector 5 Connect the power cable connector P3 to the power connector on the SAS backplane. See Figure 3-12. 6 Connect the baseboard management controller (BMC) inter-IC (I2C) cable to the SAS backplane. See Figure 3-12. 7 Connect the other end of the BMC I2C cable to connector BP_I2C on the system board. See "System Board Connectors" on page 118. 8 If not already installed, install the SAS controller card. See "Installing an Expansion Card" on page 72 for instructions about installing the card. 9 Connect the SAS data cable to the SAS controller card, and to the SAS interface connector on the backplane. See Figure 3-13 and Figure 3-12. 10 Close the system. See "Closing the System" on page 47. 11 Stand the system upright. 62 Installing System Components