Dell PowerEdge 840 Hardware Owner's Manual (PDF) - Page 60
Installing an Hard Drive in the Lever-Release Drive Carrier - scsi driver
View all Dell PowerEdge 840 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 60 highlights
Figure 3-11. Removing or Installing a SCSI Hard-Drive Carrier 1 2 1 hard-drive carrier handle 2 lever-release drive carrier Installing an Hard Drive in the Lever-Release Drive Carrier 1 Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet. 2 Remove the bezel. See "Removing the Bezel" on page 43. 3 Open the hard-drive carrier handle. See Figure 3-11. NOTICE: Do not insert a hard-drive carrier and attempt to lock its handle next to a partially installed carrier. Doing so can damage the partially installed carrier's shield spring and make it unusable. Ensure that the adjacent drive carrier is fully installed. 4 Insert the hard-drive carrier into the drive bay. See Figure 3-11. 5 Close the hard-drive carrier handle to lock it in place. 6 Install the bezel. See "Installing the Bezel" on page 47. 7 Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals. 8 Install any required device drivers. 60 Installing System Components