Dell PowerEdge 840 Hardware Owner's Manual (PDF) - Page 55
Installing a Hard Drive in the Drive Bay
View all Dell PowerEdge 840 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 55 highlights
Figure 3-8. Installing or Removing a Hard Drive 2 3 4 5 6 1 1 hard-drive bay 4 drive cable 2 screws (4 per drive) 5 power cable connector 3 hard drive 6 hard drive bay Installing a Hard Drive in the Drive Bay NOTE: Hot-plug capability is supported only when the SAS backplane is installed. For more information, see "HotPlug SATA Hard Drives Using the SAS Backplane" on page 61. 1 Unpack the drive (and controller card, if applicable), and prepare the drive for installation. For instructions, see the documentation that accompanied the drive. Installing System Components 55
Installing System Components
55
Figure 3-8.
Installing or Removing a Hard Drive
Installing a Hard Drive in the Drive Bay
NOTE:
Hot-plug capability is supported only when the SAS backplane is installed. For more information, see "Hot-
Plug SATA Hard Drives Using the SAS Backplane" on page 61.
1
Unpack the drive (and controller card, if applicable), and prepare the drive for installation.
For instructions, see the documentation that accompanied the drive.
1
hard-drive bay
2
screws (4 per drive)
3
hard drive
4
drive cable
5
power cable connector
6
hard drive bay
2
3
1
5
4
6