Dell XPS 600 Renegade Owner's Manual - Page 110
Installing a CD/DVD Drive
View all Dell XPS 600 Renegade manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 110 highlights
www.dell.com | support.dell.com Installing a CD/DVD Drive 1 Follow the procedures in "Before You Begin" on page 69. 2 If you are installing a new drive, unpack the drive and prepare it for installation. Check the documentation that accompanied the drive to verify that the drive is configured for your computer. If you are installing an IDE drive, configure the drive for the cable select setting. 3 Connect the new drive to the set of rails that are attached to the inside of the cover. If a set of rails is not attached inside the computer cover, contact Dell (see "Contacting Dell" on page 142). 4 If you are installing a replacement drive and the new drive does not have the bracket rails attached, remove the rails from the old drive by removing the two screws that secure each rail to the drive. Attach the bracket to the new drive by aligning the screw holes on the drive with the screw holes on the bracket rails and then inserting and tightening all four screws (two screws on each rail). drive bracket rails (2) screws (4) 5 Gently slide the drive into place until the tabs securely click into position. 6 Connect the power and data cables to the drive. If you are adding a drive that has an audio cable, connect the audio cable to the audio connector on the system board. 110 Removing and Installing Parts