Dell XPS 600 Renegade Owner's Manual - Page 138
Clearing CMOS Settings, see Turning Off Your Computer
View all Dell XPS 600 Renegade manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 138 highlights
www.dell.com | support.dell.com 5 After the Microsoft® Windows® desktop appears on your computer, shut down the computer (see "Turning Off Your Computer" on page 69). 6 Turn off the monitor and disconnect it from the electrical outlet. 7 Disconnect the computer power cable from the electrical outlet, and press the power button to ground the system board. 8 Open the computer cover (see "Opening the Computer Cover" on page 76). 9 Locate the 3-pin password jumper on the system board (see "System Board Components" on page 78) and attach the jumper to pins 1 and 2 to reenable the password feature. 10 Replace the computer cover (see "Closing the Computer Cover" on page 125). NOTICE: To connect a network cable, first plug the cable into the network wall jack and then plug it into the computer. 11 Connect your computer and devices to electrical outlets, and turn them on. Clearing CMOS Settings CAUTION: Before you begin any of the procedures in this section, follow the safety instructions located in the Product Information Guide. 1 Follow the procedures in "Before You Begin" on page 69. 2 Reset the current CMOS settings: a Locate the 3-pin CMOS jumper (RTCRST) on the system board (see "System Board Components" on page 78). b Remove the jumper plug from pins 1 and 2. c Place the jumper plug on pins 2 and 3 and wait approximately 5 seconds. d Replace the jumper plug on pins 1 and 2. 3 Close the computer cover (see "Closing the Computer Cover" on page 125). NOTICE: To connect a network cable, first plug the cable into the network wall jack and then plug it into the computer. 4 Connect your computer and devices to electrical outlets, and turn them on. 138 Appendix