Dell XPS 600 Renegade Owner's Manual - Page 99
If you are adding a second hard drive, remove the first hard drive from the upper bay
View all Dell XPS 600 Renegade manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 99 highlights
drive bracket rails (2) screws (4) 7 If you are adding a second hard drive, remove the first hard drive from the upper bay and install it in the lower bay: a Disconnect the power and the hard-drive cables from the back of the first hard drive. b Press in the two rail tabs and pull the first hard drive out of the upper bay. c Gently slide the first hard drive into the lower bay until it clicks into place. d Reconnect the power and hard-drive cables to the back of the first hard drive. 8 Install the hard drive into the computer by gently sliding the drive into place until the tabs securely click into position. NOTE: If you are installing a hard drive in the lower bay, place the drive in the bay so that the power connector is on the left-hand side (opposite of the top hard drive) hard-drive cable power cable tabs (2) hard drive system board connector Removing and Installing Parts 99