HP 6125G HP 6125G & 6125G/XG Blade Switches ACL and QoS Configuration - Page 53
Configuration example, Network requirements, Configuration procedure, Configuring SP+WFQ queuing
View all HP 6125G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 53 highlights
Configuration example Network requirements • Configure SP+WRR queue scheduling algorithm on GigabitEthernet 1/0/1, and use packet-based WRR. • Configure queue 0, queue 1, queue 2, and queue 3 on GigabitEthernet 1/0/1 to be in SP queue scheduling group. • Configure queue 4, queue 5, queue 6, and queue 7 on GigabitEthernet 1/0/1 to use WRR queuing, with the weight 2, 4, 6, and 8, respectively. Configuration procedure # Enter system view. system-view # Enable the SP+WRR queue scheduling algorithm on GigabitEthernet1/0/1. [Sysname] interface GigabitEthernet 1/0/1 [Sysname-GigabitEthernet1/0/1] qos wrr weight [Sysname-GigabitEthernet1/0/1] qos wrr 0 group sp [Sysname-GigabitEthernet1/0/1] qos wrr 1 group sp [Sysname-GigabitEthernet1/0/1] qos wrr 2 group sp [Sysname-GigabitEthernet1/0/1] qos wrr 3 group sp [Sysname-GigabitEthernet1/0/1] qos wrr 4 group 1 weight 2 [Sysname-GigabitEthernet1/0/1] qos wrr 5 group 1 weight 4 [Sysname-GigabitEthernet1/0/1] qos wrr 6 group 1 weight 6 [Sysname-GigabitEthernet1/0/1] qos wrr 7 group 1 weight 8 Configuring SP+WFQ queuing Configuration procedure To configure SP + WFQ queuing: Step 1. Enter system view. 2. Enter interface view. 3. Enable byte-count or packet-based WFQ queuing. 4. Configure SP queue scheduling. 5. Configure the scheduling weight for a queue. Command system-view interface interface-type interface-number Remarks N/A N/A qos wfq [ byte-count | weight ] By default, SP queuing is enabled. qos wfq queue-id group sp qos wfq queue-id group group-id { weight | byte-count } schedule-value By default, all the queues of a WFQ-enabled port use are in the WFQ group. By default, the scheduling weight is 1 for each queue of a WFQ-enabled port. 47