HP Color LaserJet 4730 HP LaserJet MFP and Color MFP Products - Configuring Se - Page 41
Protocol Stack, Recommended Setting, Explanation
View all HP Color LaserJet 4730 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 41 highlights
Figure 39: The Protocol Stacks: options. The following table lists each protocol with the recommended setting and an explanation: Protocol Stack IPX/SPX Recommended Setting Leave blank to disable Explanation This setting disables access for Novell servers. TCP/IP Select to enable This is the normal operating protocol for the MFPs. DLC/LLC Select to enable This setting enables the MFP to communicate at basic levels on the network. AppleTalk Leave blank to disable This protocol provides access to older Apple and Macintosh computers. It should be disabled if not in use. 10. Select the devices to configure in the Device List, and click Configure Devices. The View Log page will appear to show the status of the configurations. Click Refresh to update the status. Once the View Log shows success, click Go Back to continue. Configurations on the Security page The Security Configuration page lists options that are important to MFP security. Note: Some security-related settings that do not apply to LaserJet and Color LaserJet MFPs might appear on the Security page. These settings are for other types of HP MFPs. You should configure the settings that appear in the instructions below. You may wish to configure the other settings as a safeguard, but they are ignored on devices that do not support them. Follow these instructions: 1. Click Security in the Configuration Categories menu. This opens the Security configuration page (Figure 40). HP LaserJet and Color LaserJet MFP Security Checklist 41