HP Designjet 2000/3000cp HP DesignJet 2500/2000CP Printer - User's Guide - Page 249
The Automatic Cutter does not Cut Immediately after a Print has Finished
View all HP Designjet 2000/3000cp manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 249 highlights
Troubleshooting Solving Media-Handling Problems The Automatic Cutter does not Cut Immediately after a Print has Finished n If you have the Take Up Reel accessory installed the cutter is disabled, it will only cut when you perform the unloading procedure see page 3-26, Unloading Media from the Take Up Reel accessory. n Check the Page format / Margins setting. When this is set to Smaller, the printer waits until the next print begins printing so it can create a 10-mm margin between prints or nesting sets. n If you need to cut the media before the ink-drying time has passed or before the next print begins printing, press Form Feed and Cut key on the front panel. Check the ink-drying time and change if necessary (Device setup / Drying time). The Automatic Cutter does not Work n The automatic cutter is activated only when roll media is loaded. n The automatic cutter may be disabled from the front-panel menu. Go to Device setup / Cutter menu and check if the cutter is set to on or off; change it if necessary. n Your software application may have disabled the automatic cutter. Refer to your software documentation or contact your software vendor for more information. 11-29