HP Designjet 510 HP Designjet 510 Printer series - User's Guide: English - Page 136
Advance, calibration, Enter, Either, empty cartridges must be replaced before the printheads are
View all HP Designjet 510 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 136 highlights
Front-panel messages Message Explanation and action Problem found during calibration Problems detected in INK CARTRIDGES. Continue process and replace them. Press ENTER to continue Reload paper Replace empty cartridges before replacing printheads Right edge of roll too far from load line Press ENTER to retry Press CANCEL to abort A general problem was found during the Advance calibration routine. Respond to any other messages that appear on the front panel, indicating ink or paper problems, and then retry the Advance calibration routine. There is an error with the ink cartridges during the preparation of the ink system. Press the Enter key and then follow the instructions to replace the faulty ink cartridges. There is an error in the paper, as shown in another message. Use the normal procedure to reload the paper. You have requested the printer to permit printhead replacement, but the printer has detected that one or more cartridges are empty. The empty cartridges must be replaced before the printheads are replaced. Press the Enter key and follow the procedure for replacing empty cartridges, described in Ink cartridge replacement. The paper is out of the load line margins-too far from the line where it should be loaded. Either: Press the Enter key to restart the loading procedure; Or: Press the Cancel key to cancel paper loading.