HP Surestore Tape Library Model 2/28 HP DLT Tape Library 28/48-Slot - User& - Page 51

NOTE Library Operation Entering the Administration Menu Password Entering the Administration Menu Password 1 2 3 4 ADMIN* PSWD 000-000-000 CONFIG* A numeric password is required to access options beneath ADMIN* menu of the library (see Figure 4-2 on page 4-6). A three-part password of 000-000-000 is set at the factory. To allow only authorized persons to access the library and change operation settings, the password must be changed. To change the password, see "Setting a New Administration Menu Password" on page 4-8. Do not forget the password. Only an HP qualified service representative can reset the security code to the factory setting. To enter the password: 1. Verify that the drive status displays (if not, press CANCEL until it does). 2. Press NEXT until ADMIN* displays, then press ENTER. 3. PSWD 000-000-000 displays, and the first set of zeros flashes. Press ENTER to accept this number (if no password has been set), or press NEXT or PREV until the set number displays. Press ENTER. 4. The middle set of zeros flashes. Press ENTER to accept this number (if no password has been set), or press NEXT or PREV until the set number displays. Press ENTER. 5. The last set of zeros flashes. Press ENTER to accept this number (if no password has been set), or press NEXT or PREV until the set number displays. Press ENTER. INFO* displays. To access options under the ADMIN* menu, press PREV or NEXT until the desired option displays, then press ENTER. Library Operation 4-7