IBM 689912U Hardware Maintenance Manual - Page 201
Administrator Password, Riser Card, Jumper/Switch on System Board, Refer to Riser Card Layouts
View all IBM 689912U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 201 highlights
Administrator Password: The administrator password is used to restrict access to the Configuration/Setup Utility program. If the administrator password is activated, and you do not enter the administrator password, the configuration can be viewed but not changed. Note Type 6862, 6892, 6889, has Enhanced Security Mode. If Enhanced Security mode is enabled and there is no password given, the computer will act as if Enhanced Security is disabled. If Enhanced Security is Enabled and an administrator password is given, the administrator password must be entered to use the computer. If the administrator password is lost or forgotten, the system board in the computer must be replaced in order to regain access to the Configuration/Setup Utility program. For PC 700 computers, the administrator password is set by jumpering an administrator password control jumper, which can be on the riser card or the system board. Note: The administrator password control jumper will not remove the password. Administrator Password Control Jumper on Riser Card: Refer to "Riser Card Layouts" on page 388 for PC 700 Series riser cards that have an administrator password control jumper. Pins shown on the riser card are jumpered in the default (D) position. Jumper Position 1-2 (D) 2-3 Results Administrator Password can be set Administrator password cannot be set Administrator Password Control Jumper/Switch on System Board: Refer to "System Board Layouts" on page 322 and locate the system board type you are servicing. Depending on the system board, the password is set by a jumper or switch block. Reference Information 191