IBM 689912U Hardware Maintenance Manual - Page 74

Diagnostic Error Code 011-195-XXX Serial port Test aborted by user 011-196-XXX Serial port test halt, error threshold exceeded 011-197-XXX Serial port test warning 011-198-XXX Serial port test aborted 011-199-XXX Serial port test failed, cause unknown 011-2XX-XXX Serial port signal failure 014-000-XXX Parallel port Interface Test Passed 014-001-XXX Parallel port Presence 014-002-XXX 014-003-XXX Parallel port Timeout/Parity error 014-013-XXX 014-014-XXX Parallel port Control Signal/Loopback test failure 014-015-XXX Parallel port External Loopback failure FRU/Action 1. Information 2. Re-start the test, if need to 1. Depress F3 to review the log file. See "Viewing the Test Log" on page 209. 2. Re-start the test to reset the log file. 1. Make sure component that is called out is enabled and/or connected 2. Re-run test 3. Component that is called out in warning statement 4. Component under test 1. If a component is called out, make sure it is enabled and/or connected 2. Flash the system and re-test 3. Go to "Undetermined Problem" on page 81 1. Go to "Undetermined Problem" on page 81. 2. Flash the system and re-test 3. Replace component under function test. 1. External serial device 2. System board 1. No action 1. Remove external parallel device, if present 2. Run setup, enable port 3. System board 1. System board 1. System board 1. Wrap plug 2. System board 64 IBM PC 300/700, IntelliStation Series HMM