Icom IC-M804 Instruction Manual - Page 15
Receiving and transmitting, Receiving, Transmitting, DSC Scan
View all Icom IC-M804 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
BASIC OPERATION 4 ■ Receiving and transmitting D Receiving 1. Select a channel by rotating [CH/GRP] or pushing the Keypad keys. (p. 9) 2. When receiving a call, rotate [VOL] to adjust the audio output level. TIP: When a call is received: • RX is displayed. • You can hear received audio from the speaker. • The S-meter displays the received signal strength. [◄]/[►] Software Keys [CH/GRP] Keypad keys 4 [VOL] D Transmitting 1. Select a channel by rotating [CH/GRP] or pushing the Keypad keys. (p. 9) 2. Push [◄] or [►] until TX FREQ Monitor is displayed in the Software Key area. 3. Hold down TX FREQ Monitor to temporarily monitor the transmit frequency of the selected channel. • TX blinks while holding down. NOTE: If the channel is busy, wait until it becomes clear or change to another channel. 4. Hold down [PTT] on the handset and speak into the microphone at your normal voice level. • TX is displayed while transmitting. NOTE: If "SWR" is displayed during transmission, check your antenna system. 5. Release [PTT] to receive. • RX is displayed. NOTE: The Time-out Timer function cuts OFF transmission after 16 minutes of continuously transmitting. TIP: To maximize the readability of your transmitted signal, pause for a second after holding down [PTT]. Hold the microphone 5 to 10 cm from your mouth, and then speak at your normal voice level. ■ DSC Scan To receive a DSC call, such as an Individual call or a Group call, push [D-SCAN] to enter the DSC watch mode. DSC watch mode [D-SCAN] NOTE: The following frequencies are always automatically monitored with this transceiver. 2187.5, 4207.5, 6312.0, 8414.5, 12577.0, and 16804.5 kHz The setting for monitoring these frequencies can be changed in the Scanning Receiver setting. (p. 48) 10