Icom IC-M804 Instruction Manual - Page 75
Fuse replacement, CAUTION
View all Icom IC-M804 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 75 highlights
8 CONNECTIONS AND INSTALLATION ■■Fuse replacement The transceiver has 2 fuses to protect internal circuitry. If the transceiver stops functioning, and only after confirming a fuse is probably blown, check the fuses below. •• DC-DC converter unit: APS 58 V 5 A •• PA unit: APS 58 V 5 A CAUTION: Disconnect the DC power cable from the transceiver before replacing a fuse. 1. Unscrew the 4 cap bolts from the top case with a 6 mm Allen wrench. 3. Unscrew the 26 screws from the shield covers, and then open the covers. 8 2. Open the Main unit, and then disconnect 1 flat and 2 coaxial cables, as shown below. Flat cable Coaxial cables CAUTION: Disconnect the DC power cable from the transceiver before replacing a fuse. 4. Replace the circuitry fuses, as shown below. Fuse in DC-DC converter unit Fuse in PA unit CAUTION: When removing a fuse, use longnose pliers to protect your fingers and the fuse holders. 5. Replace the shield covers, flat cable, coaxial cables, and top case to their original locations. 70