Icom IC-M804 Instruction Manual - Page 49
Receiving a Geographical Area call, Receiving a Position Request call
View all Icom IC-M804 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 49 highlights
DSC OPERATION 6 TIP: When Pause is pushed in step 2, the countdown will be paused. Push Resume to resume the countdown. D Receiving a Geographical Area call When a Geographical Area call is received: • The emergency alarm sounds until you turn it OFF. • "Received Geographical" is displayed. 1. Push Alarm Off to turn OFF the alarm. D Receiving a Position Request call NOTE: When "Position ACK" is set to "Auto (Able)," the transceiver automatically sends an Acknowledgment. (p. 49) In that case, both the TX and RX calls are saved in the Transmitted and Received Call Logs. (p. 46) When a Position Request is received: • The emergency alarm sounds until you turn it OFF. • "Received Position Request" is displayed. 1. Push Alarm Off to turn OFF the alarm. 6 When "Accept after 10 sec." or "Ignore after 10 sec." is selected in the CH Auto Switch setting, the countdown is displayed on the bottom of the window. (p. 50) After 10 seconds have passed since Alarm Off was pushed, the screen will move to the DSC Task screen, or return to the Main screen. 2. Push the Software Key below the intended operation. 2. Push the Software Key below the intended operation. Ignore Hold Pause Accept : Ignores the call and returns to the Main screen. : Puts the RX task on hold and returns to the Main screen. : Pauses the countdown. : Enters the DSC Task mode immediately. Rotate Ignore Hold Able Unable Accept : Ignores the call and returns to the Main screen. : Puts the RX task on hold and returns to the Main screen. : Sends an Acknowledgment with the position and time data. : Sends an Acknowledgment with no position and time data. : Immediately enters the DSC Task mode. Rotate • Monitor the voice frequency specified by the calling station. Rotate [CH/GRP] to confirm the call contents. See page 23 for details of the Software Key functions in the DSC Task mode. 3. Push Standby Mode , and then OK to return to the Main screen. TIP: When Pause is pushed in step 2, the countdown will be paused. Push Resume to resume the countdown. Rotate [CH/GRP] to confirm the call contents. See page 23 for details of the Software Key functions in the DSC Task mode. 3. Push Standby Mode , and then OK to return to the Main screen. TIP: See pages 35 and 36 for details of the Position Request Acknowledgment procedures. 44