Icom IC-R20 Instruction Manual - Page 12

QUICK REFERENCE GUIDE ■ Programmed scan operation 25 pairs, 50 channels of memories are used for programmed scan operation, that specify a scanning range. The programmed scan scans between "xxA" and "xxB" (xx=00 to 24) frequencies. Therefore, before operating the programmed scan, different frequencies must be programmed into "A" and "B" channels. D Programming scan edges A start frequency must be programmed into a "xxA," and end frequency must be programmed into a "xxB" memory channel. 1. Setting frequency In VFO mode, set the desired receive frequency mode. • When "µ " indicator is displayed, push [VFO MHz] to select the VFO mode. 2. Selecting a scan edge channel "A" Push [MR S.MW] for 1 sec., then rotate [R-DIAL] to select one of the desired scan edge channel "A indicator blinks. FM 146..010µ 03A -BANK-:----BNAME: Top DUALWATCH MAIN/SUB POWER BAND VFO MHz MODE SCAN MR S.MW 1 2 3 SCOPE 4 5 6 0 AFC 7 8 9 LOCK REC MR S.MW Front VII 3. Writing a memory channel Push [MR S.MW] for 1 sec. until 3 beeps sound. • Scan edge channel "B" is automat- ically selected when continuing to push [MR S.MW] after programming. • After programming is completed, return to VFO indication. DUALWATCH MAIN/SUB POWER BAND VFO MHz MODE SCAN MR S.MW 1 2 3 SCOPE 4 5 6 0 AFC 7 8 9 LOCK REC MR S.MW Front 4. Selecting a scan edge channel "B" Push [MR S.MW] for 1 sec., then rotate [R-DIAL] to select one of the desired scan edge channel "B indicator blinks. • When the scan edge channel "B" is al- ready selected at step 3. (continuing to push [MR S.MW] after programming), skip this step. FM 146..010µ 03B -BANK-:----BNAME: Top DUALWATCH MAIN/SUB POWER BAND VFO MHz MODE SCAN MR S.MW 1 2 3 SCOPE 4 5 6 0 AFC 7 8 9 LOCK REC MR S.MW Front 5. Writing a memory channel Push [MR S.MW] for 1 sec. until 3 beeps sound. • The next scan edge channel "A" is automatically selected when con- tinuing to push [MR S.MW] after programming. • After programming is completed, return to VFO indication.