Icom IC-R20 Instruction Manual - Page 79

OTHER FUNCTIONS 11 • Automatic recording The IC-R20 has an automatic recording function. When this function is activated, the receiver will record automatically when a receiving signal appears and pause when the signal disappears. This function is very useful when you want to store an uncontinuous signal. qPush [ REC] for 1 sec. to enter the recording set mode. wRotate [R-DIAL] to select "REC REMOTE," then push [ REC]. *****-REC QUALITY >REC-REMOTE -ALL-DELETE REC-REMOTE OFF >ON eRotate [R-DIAL] to select the setting, then push [ REC]. rPush [DUALWATCH] to exit the recording set mode. tPush [ REC] to activate. NOTE: Before using this function, verify the squelch setting as close level when no signal is received. Otherwise this function will not pause even when signal disappears. • Erasing recorded audio NOTE: The IC recorder can erase all the tracks at the same time, but cannot erase each track independently. Only using the optional CS-R20 CLONING SOFTWARE can store the recorded audio into a PC or erase independently. qPush [ REC] for 1 sec. to enter the recording set mode. wRotate [R-DIAL] to select "ALL DELETE," then push [ REC]. *****-REC QUALITY -REC-REMOTE >ALL-DELETE ALL-DELETE NO >YES eRotate [R-DIAL] to select "YES" if you want to delete all 11 tracks, then push [ REC]. • After deleting, the receiver returns to normal operating mode. NOTE: The optional CS-R20 can perform the storing the recorded contents into PC, erasing them independently or editing their information. The CS-R20 cannot playback the stored contents on the PC. The recorded contents can be played back on the IC-R20 only. 66