Icom IC-R20 Instruction Manual - Page 62

10 SET MODE ■ General Set mode is used for programming infrequently changed values or conditions of functions. In addition, the IC-R20 has an expanded set mode which is used for programming even more infrequently changed values or conditions of functions. When turning the expanded set mode OFF, only about one third of the set mode items are displayed for simple operation. D Set mode entering and operation q Push [8 SET] for 1 sec. to enter set mode. wRotate [R-DIAL] to select the desired item, then push [8 SET]. eRotate [R-DIAL] to select the desired value or condition, then push [8 SET] to return the setting item selection mode. rPush [DUALWATCH] to exit set mode, or rotate [R-DIAL] to select another set mode item. DUALWATCH MAIN/SUB POWER BAND DIAL.SEL VFO MHz SWEEP 1 2 T-SCAN SKIP 4 5 TONE SET 7 8 ATT RF GAIN MODE SCAN CENTER MR S.MW 3 SCOPE M.N 6 0 AFC TS 9 LOCK IC Recorder REC DUALWATCH SET 8 ***-SET-MODE PRIORITY-WATCH -KEY-TOUCH-BEEP -BEEP-LEVEL -BACKLIGHT -POWER-SAVE -NOISE-BLANKER D Expanded set mode ON/OFF q Push [8 SET] for 1 sec. to enter set mode. w Rotate [R-DIAL] to select "SET EXPAND." ***-SET-MODE NOISE-BLANKER -ANL -AF-FILTER -AM-ANTENNA -FM-ANTENNA >SET-EXPAND ePush [8 SET] to enter "SET EXPAND," rotate [R-DIAL] to select the expanded set mode ON and OFF, then push [8 SET]. SET-EXPAND OFF -ON SET-EXPAND OFF >ON Expanded set mode OFF Expanded set mode ON r Rotate [R-DIAL] to select the desired item. tPush [8 SET] to enter the item, rotate [R-DIAL] to select the desired value or condition, then push [8 SET]. yPush [DUALWATCH] to exit set mode, or rotate [R-DIAL] to select another item. 49