Icom IC-R20 Instruction Manual - Page 42

6 MEMORY CHANNELS ■ Programming memory/bank name Each memory channel can be programmed with an alphanumeric channel name for easy recognition and can be indicated independently by channel. Names can be a maximum of 8 characters. q Push [MR S.MW] to select memory mode. w Rotate [R-DIAL] to select the desired memory channel. ePush [MR S.MW] for 1 sec. to select the select memory write condition. • 1 short and 1 long beep sound. • "µ " indicator blinks. FM 145..700µ 012 >BANK-:C-11 rWhile pushing [8 SET], rotate [R-DIAL] to select "BNAME" or "MNAME" when programming the memory name or the bank name, respectively. • The item can also be selected by pushing [8 SET] several times. • After selecting the memory or bank name programming condi- tion, a cursor blinks for the first digit. Bank name selection Memory name selection FM 145..700µ 012 -BANK-:C-11 >BNAME: -MNAME: FM 145..700µ 012 -BANK-:C-11 >BNAME: >MNAME: tRotate [R-DIAL] to select the desired character. • The selected character blinks. • While pushing [6 M.N], rotate [R-DIAL] to select the character group. yWhile pushing [BAND], rotate [R-DIAL] to move the cursor to left or right. • Push [BAND] to move the cursor to right. Bank name Memory name FM 145..700µ -BANK-:C-11 >BNAME:GRO -MNAME: 012 FM 145..700µ -BANK-:C-11 >BNAME: >MNAME:Ric 012 uRepeat steps t and y until the desired 8-character channel names are displayed. iPush [MR S.MW] for 1 sec. to program the name and exit the channel name programming condition. • 3 beeps sound. NOTE: Only one bank name can be programmed into each bank. Therefore, the previously programmed bank name will be displayed when bank name indication is selected. Also, the programmed bank name is assigned for the other bank channels automatically. 29