Icom IC-R20 Instruction Manual - Page 47

7 SCAN OPERATION ■ Scan types Scanning searches for signals automatically and makes it easier to locate new stations for contact or listening purposes. There are 7 scan types and 4 resume conditions to suit your operating needs. The scan speed is at 100 ch/sec. (approx.) for VFO scan, 20 ch/sec. (approx) for memory scan. FULL SCAN (p. 35) Repeatedly scans all frequen- SELECTED BAND SCAN Repeatedly scans all frequen- 150 kHz cies over the entire band. 3304.999 MHz (p. 35) Band cies over the entire selected Band band. 6 Some frequency ranges are edge edge Scan not scanned according to the Scan frequency coverage of the re- Jump ceiver's version. Jump PROGRAMMED SCAN (p. 37) Band Scan edges Band edge xxA xxB edge Scan Jump Repeatedly scans between two user-programmed frequencies. Used for checking for frequencies within a specified range such as repeater output frequencies, etc. MEMORY (SKIP) SCAN Repeatedly scans memory (p. 37) channels except those set as SKIP skip channel. Skip channels M 1 M 2 M 3 can be turned ON and OFF M 0 M 199 M 6 M 4 by pushing and holding [5 SKIP SKIP] in memory mode. M 5 ALL/SELECTED BANK SCAN (p. 37) SKIP A00 A01 A02 Repeatedly scans all bank channels or selected bank channels. The skip scan is also available. A99 A03 SKIP A98 A05 A04 FREQUENCY/MEMORY SKIP FUNCTION (p. 39) Band edge Band edge Scan SKIP Jump SKIP Skips unwanted frequencies or channels that inconveniently stop scanning. This function can be turned ON and OFF by pushing and holding [5 SKIP] in either VFO or memory mode. 34