Icom IC-R20 Instruction Manual - Page 48
Full/band/programmed scan
View all Icom IC-R20 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 48 highlights
7 SCAN OPERATION ■ Full/band/programmed scan q Select VFO mode with [VFO MHz]. • Select the desired frequency band with [BAND], if desired. w Set the squelch level. eWhile pushing and holding [MODE SCAN], rotate [R-DIAL] to select the desired scanning type. • "ALL" for full scan; "BAND" for band scan, "PROG-xx" for pro- grammed scan (xx= 0 to 24; programmed scan edges numbers only displayed) [R-DIAL] VFO MHz MODE SCAN • Full scan selection -DUP TSQL AFC MODE FM ANL 146 010 √ SCAN:ALL PSKIP • Band scan selection √ SCAN:BAND PSKIP • Programmed scan selection PSKIP √ SCAN:PROG-01 Selectable between " 00" to "24" if programmed r To start the scan, release [MODE SCAN]. • Scan pauses when a signal is received. • Rotate [R-DIAL] to change the scanning direction, or resumes manually. • Push [DUALWATCH] again to stop the scan. • During full/band scan • During programmed scan -DUP TSQL AFC MODE FM ANL 148 800 PSKIP √ -DUP TSQL AFC MODE FM ANL 148 800 PSKIP √ P01 About the scanning steps: The selected tuning step in each frequency band (in VFO mode) is used during scan. 35