Icom IC-R20 Instruction Manual - Page 67

SET MODE 10 D Dial speed acceleration The dial speed acceleration automatically speeds up the tuning dial speed when rotating [R-DIAL] rapidly. • OFF : The dial speed acceleration is turned OFF. • ON : The dial speed acceleration is tuned ON. (default) DIAL-SPEED-UP OFF -ON DIAL-SPEED-UP OFF >ON The acceleration OFF The acceleration ON D Monitor key action The monitor key, [SQL], can be set as a 'sticky' key. When set to the sticky condition, each push of [SQL] toggles the monitor function ON and OFF. • PUSH : Pushing and holding [SQL] to monitor the frequency. (default) • HOLD : Push [SQL] to monitor the frequency and push again to cancel it. MONITOR PUSH -HOLD MONITOR PUSH >HOLD Push to monitor Push and hold [SQL] to monitor D Auto power OFF The receiver can be set to automatically turn OFF after a specified period has past. 30 min., 1 hour, 1.5 hours, 2 hours, BUSY and OFF (default) can be specified. The specified period is retained even when the receiver is turned OFF by the auto power OFF function. To cancel the function, select "OFF" in this set mode. • 30-120: The receiver automatically turns OFF (with a beep) after a specified period from last key op- eration. • BUSY : The receiver automatically turns OFF (with a beep) after 3 minutes from last key operation or signal reception. AUTO-POWER-OFF AUTO-POWER-OFF 10 -OFF -OFF >30MIN -30MIN -60MIN -60MIN -90MIN -90MIN -120MIN >120MIN -BUSY -BUSY 30 min. timer 2 hrs. timer 54