Icom IC-R20 Instruction Manual - Page 80
Partial reset, All reset
View all Icom IC-R20 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 80 highlights
11 OTHER FUNCTIONS ■ Partial reset AT POWER ON If you want to initialize the operating conditions (VFO frequency, VFO settings, set mode contents) without clearing the memory contents, a partial resetting function is available for the receiver. ➥ While pushing [VFO MHz], turn the power ON to partially reset the receiver. DUALWATCH MAIN/SUB POWER BAND DIAL.SEL VFO MHz SWEEP 1 2 T-SCAN SKIP 4 5 TONE SET 7 8 ATT RF GAIN MODE SCAN CENTER MR S.MW 3 SCOPE M.N 6 0 AFC TS 9 LOCK IC Recorder REC POWER VFO MHz -DUP TSQL AFC MODE FM ANL 146 010 PSKIP √ *The appearing frqeuency is different according to receiver version. 67 ■ All reset AT POWER ON The function display may occasionally display erroneous information (e.g. when first applying power). This may be caused externally by static electricity or by other factors. If this problem occurs, turn power OFF. After waiting for a few seconds, turn power ON again. If the problem persists, perform the following procedure. • Partial resetting is also available. See left for details. IMPORTANT!: Resetting the receiver (All reset) CLEARS all memory information and initializes all values in the receiver, including TV channel skip setting. ➥ While pushing [VFO MHz] and [MR S.MW], turn the power ON to reset the CPU. DUALWATCH MAIN/SUB POWER POWER ALL-RESET BAND DIAL.SEL VFO MHz SWEEP 1 2 T-SCAN SKIP 4 5 TONE SET 7 8 ATT RF GAIN MODE SCAN CENTER MR S.MW 3 SCOPE M.N 6 0 AFC TS 9 LOCK IC Recorder REC MR S.MW VFO MHz -DUP TSQL AFC MODE FM ANL 146 010 PSKIP √ *The appearing frqeuency is different according to the receiver version.