Icom IC-R20 Instruction Manual - Page 56

8 PRIORITY WATCH ■ Priority watch operation D Memory channel watch and memory scan watch q Select VFO mode; then, set an operating frequency. w Set the watching channel(s). For memory channel watch: Select the desired memory channel. For memory scan watch: Select memory mode, or the desired bank group; then, push [MODE SCAN] for 1 sec. to start memory/bank scan. e Push [8 SET] for 1 sec. to enter set mode. rRotate [R-DIAL] to select "PRIORITY WATCH," then push [8 SET]. tRotate [R-DIAL] to turn the priority watch ON, then push [8 SET]. • Select "BELL" if the priority beep function is necessary. [R-DIAL] MODE SCAN MR S.MW SET 8 ***-SET-MODE PRIORITY-WATCH -KEY-TOUCH-BEEP -BEEP-LEVEL -BACKLIGHT -POWER-SAVE -NOISE-BLANKER PRIORITY-WATCH OFF >ON -BELL 43 y Push [DUALWATCH] to exit set mode and start the watch. • "PRIO" indicator appears. • The receiver checks the memory/bank channel(s) every 5 sec. • The watch resumes according to the selected scan resume condition. (p. 41) • During priority watch -DUP TSQL AFC MODE FM ANL 439 975 -DUP TSQL AFC MODE FM ANL 145 870 PSKIP √ PRIO µ 001 PSKIP √ PRIO µ 001 Monitors VFO frequency for 5 sec. Pauses on a memory (bank) channel when a signal is received. • During priority watch with priority beep -DUP TSQL AFC MODE FM ANL 439 975 -DUP TSQL AFC MODE FM ANL 145 870 PSKIP √ PRIO µ 001 PSKIP √ PRIO µ 001 Emits beep and blinks "S" indicator when a signal is received on a memory (bank) channel. u Push [DUALWATCH] to cancel the watch.