Icom IC-R20 Instruction Manual - Page 27

3 FREQUENCY AND CHANNEL SETTING ■ Setting a tuning step The tuning step can be selected for each frequency band independently, however, the tuning steps, 8.33 kHz and 9 kHz, only appear when setting the tuning step for the VHF air band and AM broadcast band, respectively. The following tuning steps are available for the IC-R20. • 0.01 kHz • 0.1 kHz • 1.0 kHz • 5.0 kHz • 6.25 kHz • 8.33 kHz* • 9.0 kHz* • 10.0 kHz • 12.5 kHz • 15.0 kHz • 20.0 kHz • 25.0 kHz • 30.0 kHz • 50.0 kHz • 100.0 kHz * Available for some frequency band only. D Tuning step selection q Push [VFO MHz] to select VFO mode, if necessary. w Push [BAND] to select the desired frequency band. • Or, while pushing and holding [BAND], rotate [R-DIAL] to select the desired frequency band. e Push [9 TS] for 1 sec. to enter tuning step selecting condition. r Rotate [R-DIAL] to select the desired tuning step. t Push [9 TS] to return to VFO mode. [R-DIAL] BAND VFO MHz TS 9 -DUP TSQL AFC MODE FM ANL 146 010 PSKIP √ SET TS:5.0kHz 5 kHz tuning step ■ Setting a frequency D Using the dial q Push [VFO MHz] to select VFO mode, if necessary. w Select the desired frequency band with [BAND]. 3 • Or, while pushing and holding [BAND], rotate [R-DIAL] to select the desired frequency band. e Rotate [R-DIAL] to select the desired frequency. • The frequency changes according to the preset tuning steps. See the left section for setting the tuning step. • Push [VFO MHz] for 1 sec. then rotate [R-DIAL] to change the frequency in 1 MHz steps, or push for 1 sec. again then rotate [R-DIAL] to change the frequency in 10 MHz steps. (Each push for 1 sec. toggles 1 MHz or 10 MHz tuning steps.) [R-DIAL] MODE FM 146 010 00 [R-DIAL] changes the fre- quency according to the se- BAND lected tuning step. VFO MHz MODE FM 146 010 00 While pushing [VFO MHz], [R-DIAL] changes the frequency in 1 MHz steps (default). 14