Kyocera ECOSYS M6526cdn ECOSYS M6026cdn/M6526cdn/Type B Operation Guide - Page 489

Troubleshooting Symptom Checkpoints Corrective Actions Printouts are too dark. Copies have a moire pattern (dots grouped together in patterns and not aligned uniformly). Printouts are not clear. Printouts are dirty. Printouts are fuzzy. - Is the machine in Auto Density mode? Is the machine in Manual Density mode? - Is the original a printed photograph? Did you choose appropriate image quality for the original? Is the platen or the document processor dirty? Is the machine being used in very humid conditions? Run [MC] and decrease the adjustment value. Decrease the adjustment value 1 level at a time from the current value. If there is no improvement after the value is decreased by 1 level, decrease by 1 level again. If there is still no improvement, return the setting to the original value. Select the correct density level for auto density. Select the correct density level. Conduct color calibration using the operation panel. Set the image quality to [Photo]. Select appropriate image quality. Clean the platen or the document processor. Use in a location that has suitable humidity. Reference Page 8-138 - 5-16 8-126 5-15 5-15 - - 10 Images are skewed. Paper often jams. Are the originals placed correctly? Is the paper loaded correctly? Is the paper loaded correctly? Is the paper of the supported type? Is it in good condition? When placing originals on the platen, align them with the original size indicator plates. When placing originals in the document processor, align the original width guides securely before placing the originals. Check the position of the paper width guides. Load the paper correctly. Remove the paper, turn it over, and reload it. 2-65 2-66 2-66 2-47 2-47 10-3