Kyocera ECOSYS M6526cdn ECOSYS M6026cdn/M6526cdn/Type B Operation Guide - Page 500
Scan To Email Error Code, Error Code:1101
View all Kyocera ECOSYS M6526cdn manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 500 highlights
Troubleshooting Error Message Checkpoints Corrective Actions Reference Page Error Code:2101, Did you enter an invalid host Enter the correct host name or IP - 2102, 2103, 2201, 2202, name or IP address? address. 2203, 2231, 3101 Is the wrong port number Specify the correct port number. - specified? Are you correctly connected Make sure that the network cable has - to the network? been correctly connected. Make sure that the network environment (server, hub, or other LAN network) is operating correctly. Error Code:4701, - 5101, 5102, 5103, 5104, 7102, 720f Turn the main power switch off and - then on. If this occurs repeatedly, write down the error code that appears in the message display and contact a service technician. (See the procedure in Machine failure. Call service.) Error Code:9181 Have more than 999 original If there are more than 999 original - pages been scanned? pages, send the pages in separate batches. Error Code:1101 Error Code:1102 Scan To Email Error Code Is the SMTP/POP3 server Set the correct server name in - name incorrect? Command Center RX. Did you specify an invalid Enter the correct user name and - user or password? password. Error Code:1104 Did you specify the destination address? Specify the destination address. - Error Code:1105 Is SMTP protocol enabled? Enable SMTP protocol in Command - Center RX. Error Code:2101, Is "Other Authenticate" Select a valid POP3 user other than - 2102, 2103, 2201, 2202, selected when POP before "Other". 2203 SMTP authentication is performed? Is the specified server an Set the correct server name in - SMTP server? Command Center RX. Error Code:2204 Are you correctly connected Make sure that the network cable has - to the network? been correctly connected. Make sure that the network environment (server, hub, or other LAN network) is operating correctly. Were you attempting to send too much data? Change the size that can be sent in - Command Center RX. 10-14