Kyocera KM-6030 6030/8030 Operation Guide (Basic Edition) Rev-4 - Page 53
B4 or 11 × 17 A3.
View all Kyocera KM-6030 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 53 highlights
1 Adjust the original width guides to fit the originals. Preparing to Copy 2 Place the originals. Put the side to be copied (or the first side of two-sided originals) face-up. Slide the leading edge into the document processor as far as it will go. IMPORTANT: Confirm that the original width guides exactly fit the originals. If there is a gap, readjust the original width guides. The gap may cause the originals to jam. Pull out the ejection guide for originals of 8 1/2 × 14" (B4) or 11 × 17" (A3). Ensure that loaded originals do not exceed the level indicated. Exceeding the maximum level may cause the originals to jam. 2-17
Preparing to Copy
2-17
1
Adjust the original width guides to fit the originals.
2
Place the originals. Put the side to be copied (or the
first side of two-sided originals) face-up. Slide the
leading edge into the document processor as far as it
will go.
IMPORTANT:
Confirm that the original width guides
exactly fit the originals. If there is a gap, readjust the
original width guides. The gap may cause the originals
to jam.
Pull out the ejection guide for originals of 8
1/2
× 14"
(B4) or 11 × 17" (A3).
Ensure that loaded originals do not exceed the level
indicated. Exceeding the maximum level may cause
the originals to jam.