Kyocera TASKalfa 181 181/221 Print Driver User Guide - Page 37

Basic Transparencies must be printed using the MP tray, and labels and envelopes require the MP tray. Ensure the paper is properly loaded by following the instructions outlined in the printing system's Operation Guide. Note: Source and Media type are separate items in the dialog box, but can be combined using the Combine source and media type lists setting in Compatibility Settings. If they are combined, Media type is not available on the Basic tab. To change this setting, open Device settings > Compatibility Settings and clear the Combine source and media type lists selection. Print Size and Page Size Print Size controls the output page size of the document. To use this setting, ensure that the Page Size setting matches the page size setting in your application. If the Print Size is different from the page size in your application, then each page will be enlarged or reduced to match the Print Size. The percentage value shown in brackets indicates the size of the Print Size setting relative to the Page Size setting. If the Page Size does not match the page size setting in the application (the size of the original), then, in most cases, the Print Size is ignored and the document prints out based on its original size. Duplex Printing Duplex printing is printing on both sides of each page. Select Print on both sides to start duplex printing. If it is not selected, then the printer prints on only one side of each page. The printer system contains a duplex unit that turns the paper over to allow printing on the reverse side. Print on both sides must be selected to print on both sides of the cover and insert pages. Flip on long edge Turn the long edge of the page to view the content, like the pages of a book bound at the side. Flip on short edge Turn the short edge of the page to view the content, like a tablet bound at the top. Flip on long edge KX DRIVER 4-3