Lexmark W810n Setup Guide (2.8 MB) - Page 113

Support shelf Finisher CAUTION! If you are installing the fin- isher sometime after initial printer setup, turn the printer off and unplug the power cord before continuing. Transport unit Guide rail Hole punch box Do not remove Guide rail bracket Set pin, magnetic bracket, and screws To set up the finisher: 1 Pull the packing box off of the finisher. 2 Remove the finisher and all other items from their packing materials. Remove any plastic wrapping, shipping tape, and protective foam. Do not remove the hole punch box on the right side of the finisher. Save the carton and packing materials in case you need to repack the finisher. 3 Remove the two bags contain- ing the guide rail bracket, set pin, magnetic bracket, and screws from inside the finisher. 4 Make sure you have the follow- ing items: - Finisher - Transport unit - Support shelf - Guide rail - Guide rail bracket - Set pin - Magnetic bracket - 3 screws If any items are missing or damaged, refer to the registration card for the designated Lexmark support phone number for your country. Set up the optional finisher 101