Lexmark W810n Setup Guide (2.8 MB) - Page 129
ledge to adjust the finisher's, Turn the knobs on the base
UPC - 734646367103
View all Lexmark W810n manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 129 highlights
1 Separate the finisher from the printer. 2 Locate the four wing bolts under the finisher's base ledge on the side that faces the printer. 3 Turn the wing bolts counter- clockwise to loosen them. 4 Turn the knobs on the base ledge to adjust the finisher's height. Turn the knobs clockwise to raise the finisher. Turn the knobs counterclockwise to lower it. 5 When the transport unit is level, tighten the wing bolts you loosened in step 3. 6 Push the finisher against the printer. Set up the optional finisher 117
117
Set up the optional finisher
1
Separate the finisher from the
printer.
2
Locate the four wing bolts
under the finisher’s base ledge
on the side that faces the
printer.
3
Turn the wing bolts counter-
clockwise to loosen them.
4
Turn the knobs on the base
ledge to adjust the finisher’s
height.
Turn the knobs clockwise to raise
the finisher. Turn the knobs coun-
terclockwise to lower it.
5
When the transport unit is level,
tighten the wing bolts you loos-
ened in step 3.
6
Push the finisher against the
printer.