Lexmark W810n Setup Guide (2.8 MB) - Page 67
Installing a hard disk, ATA-2 IDE interface
UPC - 734646367103
View all Lexmark W810n manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 67 highlights
9 Repeat steps 3 through 8 to install another option card. 10 Choose the first task in the fol- lowing table that identifies something you have left to do. Then go to the page listed. What do I do next? Task 1 Install a hard disk. 2 Reinstall the system board access cover. Go to page ... 55 59 Installing a hard disk Two hard disk options are available from Lexmark: • A hard disk with a ribbon cable already installed. • An adapter ribbon cable that you can use to install any other Lexmark or third-party hard disk meeting the following criteria: - 2.5-inch platter - ATA-2 (IDE) interface - Maximum thickness of 13 mm (0.51 in.) Install memory and option cards 55
55
Install memory and option cards
9
Repeat steps 3 through 8 to
install another option card.
10
Choose the first task in the fol-
lowing table that identifies
something you have left to do.
Then go to the page listed.
Installing a hard disk
Two hard disk options are available from
Lexmark:
•
A hard disk with a ribbon cable
already installed.
•
An adapter ribbon cable that you
can use to install any other Lex-
mark or third-party hard disk
meeting the following criteria:
—
2.5-inch platter
—
ATA-2 (IDE) interface
—
Maximum thickness of 13 mm
(0.51 in.)
What do I do next?
Task
Go to page …
1
Install a hard disk.
55
2
Reinstall the system board access cover.
59